Computer Question

[82Rigger]

I am about to upgrade the RAM in my computer.

I will be installing two 184-pin DDR266 modules.

What's the best way to eliminate possible static electricity damage?
Would wearing disposable latex examination gloves eliminate static transfer?

Thanks in advance!

Steve

[Bill Farnie]

Steve, This is from Dell's web site

Turn off your computer and all devices.
Ground yourself by touching an unpainted metal surface at the back of the computer before touching anything inside your computer.

While you work, periodically touch an unpainted metal surface on the computer to dissipate any static electricity that might harm internal components.
Disconnect the power cable to your computer, and then press the power button to ground the system board.
Disconnect any devices connected to the computer, including the monitor, from their electrical outlets to reduce the potential for personal injury or shock. Also, disconnect any telephone or telecommunication lines from the computer.
After you remove or replace parts in the system, observe the following notice to prevent damage to the system:

NOTICE: Make sure that all other system cables are connected before connecting the computer to its electrical outlet.

[39mto39g]

If your computer is pluged in to the wall it is already grounded (three prong plug). I have done this a few times, if you touch the inside of your computer before handeling the Ram you should be de-staticked? (is that a word?)
Look at the pins, There not straight, They get put in and taken out at an angle.
After install, turn your computer back on and your system should pick up the new RAM.
But, then, I was wrong, once.

Ron